Results 1 to 6 of 6
  1. #1
    Join Date
    Sep 2012
    Location
    Cass Lake, Michigan
    Posts
    27

    Default 08' Outback Gravity II Ballast Issue

    I recently purchased my 2008 Outback V with the Gravity III ballast system. At the time I tested the boat I filled the ballast to confirm everything worked. In doing so I found out the rear right ballast empty pump doesn't activate when the switch is turned on. Obviously I purchased the boat regardless...

    Having done a decent search on this forum and Owner's Manual I found it could be the following concerns:
    - Fuse Blown for ballast pump
    - Breaker on Switch Board tripped
    - Pump Fried (seems fairly common)

    I looked at the pump and found that the emptying nozzle where the hose attaches (on way to exit the hull) was cracked - So I am replacing that tomorrow regardless.

    HOWEVER - When I looked for the Fuse Bank for the ballast system I couldn't find it. I found the regular fuses for all other circuits mounted under the dash no problem - All clearly labeled.

    Am I wrong in expecting to find a separate fuse bank for the ballast????!?!?
    I'm expecting 7 total fuses for the ballast: 1 Fill Pump, 3 Valves, 3 Empty Pumps
    Can someone help me with where this would be? I'm pretty mechanically sound (won't take me longer than 30min to install the new pump tomorrow), however I'm starting to feel like an idiot on this one...if somebody has a picture of where it is located I would really appreciate it!

  2. #2
    Join Date
    Jan 2008
    Location
    Tallahassee, FL
    Posts
    11,333

    Default

    I know on the LSV the ballast fuses are WAY UP under there. I had to lay on my back with my head up under the steering wheel and extend my arms all the way up past the backs of the gauges to reach. Not a place you would notice in a quick glance, that's for sure. Not sure on your model but somebody will chime in.
    My Mom said I'm not allowed to get wet!
    2008 LSV
    2000 Outback LS (sold)
    Exile Tunes
    PWI
    LLTR!!!!!!!!



  3. #3
    Join Date
    Sep 2009
    Location
    newnan, GA
    Posts
    437

    Default

    The connectors for the empty pumps are under the v drive cover, connect the right pump to the left pump connector and verify condition. Sorry ive never checked the fuses on mine so don't know location but I have replaced 2 empty pumps

    2005 mobius lsv 2900lbs ballast
    2005 mobius lsv

  4. #4
    Join Date
    Jun 2008
    Location
    Eugene OR
    Posts
    1,712

    Default

    I am not sure on the factory setup but below is some common information on how it should be setup.

    The Breakers are under the dash at the top. I would think it would use one of these breakers or three of them. I have attached a photo for you. Take a light with you since it is hard to read what each breaker is for. Do you get a light on the switch when you turn it on? If so it is not a fuse/breaker issue. It is also not the the breaker on the G III switch panel if you get a light. The fuses/ Breakers should be before the switches. If you have a meter or just a LED light hook it up to were the empty pump plugs in and you will be able to see if you have power when you turn on the pump. All the pumps should have a quick disconnect close to were the pump is installed.

    Hope this helps

    2008 Outback V
    “Do not wait; the time will never be “just right.” Start where you stand, and work with whatever tools you may have at your command, and better tools will be found as you go along." -Napoleon Hill

  5. #5
    Join Date
    May 2009
    Location
    Carlton Oregon
    Posts
    6,043

    Default

    The picture Jester posted is the main breakers common to all the Boats. The Gravity Ballast system is considered an UPGRADE so it has a secondary fuse block. Its mounted pretty high in the dash and it has 2 or 3 fuses depending on the Gravity system you have.

    Its its own seperate small fuse block.

    On my LSV its above the steering rack and mounted to the Right of the main fuse block. Its hard to see but if you look up there with a flash light you will see it.
    Malo <--- Means--Evil or Mean One. This explains a lot.
    2013 Mojo 2.5 Skylon Tower. Bestia < Beast >
    Exile ZLD
    6 SX65M Cabins
    6 XM9 Towers
    1 XI Big 15 Woofer in a custom Fiberglass box
    1 XI 1K Harpoon
    2 XI 800.4
    1 XI 2500.1
    2 Interstate 2400U 6V Golf Cart Batterties
    Custom 1 Off Evolution Cover

  6. #6
    Join Date
    Jan 2008
    Location
    Keuka Lake, NY
    Posts
    5,964

    Default

    It is way up on the divider between the driver cubby and the bow area. It will say left right and center ballast and have fill and drain labeled as well. Each has a mini fuse.

    Looking for a pic , but my ballast upgrade is missing pics. Hmmnnn.
    A Day at the Lake...Priceless
    A Day in Powder...Endless


    Joe V
    2012 Möbius XLV~ Loaded & Exiled
    2007 Outback V ~ sold

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •