Since it seems like summer is over up here in Michigan, I decided to change all the oils in my boat today, and attack the transmission screen for the first time. I followed DOCDRS Transmission and Vdrive post, but I found a minor issue with it. The two bolts that hold the transmission screen cover plate are metric, and therefore require a 13mm wrench, not a 1/2 inch wrench. In some cases a 1/2 inch wrench may work, bot not in all. I do not know how long the transmission has been using metric hardware, but it is definately metric in the 2010's. I was going to add this to DOCDRS post, but it is closed. Hope this helps others that have tried.
Results 1 to 3 of 3
Thread: Transmission Screen Cover Wrench
09-21-2012, 10:10 PM #1
Transmission Screen Cover WrenchJoe
2010 Outback V
Rockford Fosgate P500-4 Amp
Aerial 2 Speaker 3 Light Combo with Kicker KM6200 Speakers
Upgraded Gravity I to Gravity III
LSV in the works
09-21-2012, 10:48 PM #2
Very thoughtful of you to post on this. How did it all work out for you?My Mom said I'm not allowed to get wet!
09-22-2012, 11:59 AM #3
Thanks and the post has been updated09 21v LAUNCH
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies