I ordered the Samson mirror for our LSV, should be here this week.
Results 11 to 19 of 19
Thread: New Toys/Equipment
-
01-06-2013, 11:40 PM #11
2011 Mobius LSV
Ron
-
01-08-2013, 08:55 AM #12
-
01-08-2013, 11:55 AM #13
Get a 1/2" or 3/4" (can't remember exactly what I used) and cut it to 6 ft. The drill a 1/4 hole or so in one end about 2 inches up from the end. Then take a saw and cut up the short end to the hole you drilled. Now slide the rope through the PVC with the side with the hole toward the rope handle. Once the pipe has reached the "Y" in the handle you can slide the branches of the "Y" up the slits you cut until one side is coming out of each hole. Then you want to wrap the end with electrical tape, this will keep the camera up right with the handle. Use the go pro handle bar mount to install it at the end of the 6 ft pipe.
Sent from my iPhone newtys droid killer using TapatalkDavid
2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM7, Exile SXT65Q, Exile XI12D, Exile Harpoon, Exile SM600.1 , Exile Xi800.4.
-
01-08-2013, 12:53 PM #14
And here is the result




Sent from my iPhone newtys droid killer using TapatalkDavid
2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM7, Exile SXT65Q, Exile XI12D, Exile Harpoon, Exile SM600.1 , Exile Xi800.4.
-
01-08-2013, 04:43 PM #15
Looks like an easy enough setup. I am going to give this a try this year. I had the go-pro mounted on the board but the videos are never really that good. I also mounted the camera on the back of the boat but again the video is never that great when wakeboarding because its so far away.
-
01-08-2013, 07:48 PM #16
This yields bad video as well, good for still shots tho
Sent from my iPhone newtys droid killer using TapatalkDavid
2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM7, Exile SXT65Q, Exile XI12D, Exile Harpoon, Exile SM600.1 , Exile Xi800.4.
-
01-08-2013, 08:54 PM #17
What's the electrical tape wrapped every foot or so up the PVC ?
A Day at the Lake...Priceless
A Day in Powder...Endless
Joe V
2012 Möbius XLV~ Loaded & Exiled
2007 Outback V ~ sold
-
01-08-2013, 10:36 PM #18
The handlebar mount was slightly too big so I put a good wrap of tape every foot to have multiple mounting locations and tighten up the fit a little
Sent from my iPhone newtys droid killer using TapatalkDavid
2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM7, Exile SXT65Q, Exile XI12D, Exile Harpoon, Exile SM600.1 , Exile Xi800.4.
-
01-08-2013, 10:42 PM #19

Reply With Quote

