Results 11 to 19 of 19
Thread: Where to install my amp
03-01-2013, 09:14 AM #11Member
- Join Date
- Feb 2013
Basic understanding for me at this point is to buy wood, glue to walls or bracket to floor then screw amps to that? So I take it floor is okay to drill screws into? What about drilling holes in floor to access ski locker for routing of RCA's to driver side?
03-01-2013, 01:44 PM #12
depends on the size and number of amps!
I utilized the hump in the passenger cubby to install 2 JL MHD amps but they have a really small footprint. Bigger amp boards and multiple amps may require different installation. Just another option!
Pics in my profile if you want to see?
2007 Moomba Outback - going, going, GONE
2015 "NOT A MOOMBA"
Why Not? Play Hard! Get wet
03-01-2013, 05:00 PM #13
My screws holding to the floor are probably only 3/4" long.
Back when I was a teenage know-it-all I drilled a few holes through the side of my boss's big Sea Ray hull while trying to mount speakers down in the cuddy cabin. That's a mistake you'll only make once.At the time it seemed like a good idea...
03-03-2013, 08:36 AM #14
Tanks jstenger...great link..
03-03-2013, 07:00 PM #15
Where to install my amp
This is my '08 Outback with an Exile Xi800.4 and Harpoon on the side wall, Kicker ZX1000.1 on the back of the bow seat. This is with a custom built battery box and the side brace cut to accommodate the dual battery setup;
Same boat, older system. Kicker ZX700.5, ZX350.4, and ZX100.1 - factory battery location with separate battery boxes;
If its just 1 amp your best bet is to put it on the back of the bow seat; nice and out of the way, far from the floor which is bound for moisture.BoatBling Moomba forum member discount thread
2013 Outback V
03-13-2013, 09:20 PM #16
Cool Joe!! Thanks
03-13-2013, 09:23 PM #17
Ok, I also tought of installing the amp just under the glove box
03-14-2013, 07:46 AM #182011 Xlv with 325hp and stock Gravity lll
03-14-2013, 07:51 AM #192011 Xlv with 325hp and stock Gravity lll