I am planning to start the LED CupHolder Rings project (just for fun right now) and can someone tell me what's the inside diameter for moomba boat. I was planning to cut 3 3/4 and 3 5/8 inside diameter and add 1/2" to it.I haven't set the selling price (or even calculated my cost) and was wondering how much is the reasonable price you guys think should be. I don't want to spend time if most of the consumer thinks it's an expensive.
I'm planning to use 1/4" or 6mm sheet for that.
Results 1 to 1 of 1
Thread: LED CupHolder Rings
03-21-2013, 08:25 PM #1Senior Member
- Join Date
- Feb 2013
- Norcross, GA & Lake Lanier
LED CupHolder Rings