Results 11 to 20 of 27
Thread: Not a good day
04-08-2013, 07:16 PM #11
Do you have two different names? W2W and MBalls? Almost sounds like no filter was installed09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies
04-09-2013, 04:25 AM #12
Not a good day
I have always serviced mine, and never had a problem (touch wood)....its easy peasy!
I have friends with other boats, who send them off for service, and they ALWAYS have an issue of some sort afterwards.
Human error....if it's not your pride and joy, you just don't treat it the same i think.
04-09-2013, 09:12 AM #132004 Moomba LSV Blue
04-09-2013, 09:17 AM #14Member
- Join Date
- Jun 2010
- Raleigh, NC
I would suggest you ask to see that faulty filter. Sounds like crap to me.2008 Mobius LSV, 325 Assault, Acme 1433
Ballast: 1100s rear, 400 center and IBS plumbed on valve. 3 Johnson Reversibles.
Audio: 2 SKM10 subs and 6 KM6200s powered by Kicker IX1000.5, Pair REV8s powered by JL M4300 amp, Kenwood 440u head unit, RC107 remote at helm, and RC60 remote at transom
Misc: Blue Seas Add-a-Battery, SeaDek, Evolution Cover, Blue interior LEDs, 2 Attwood Underwater LEDs
04-09-2013, 09:40 AM #15
as long as the shop gets it all cleaned up and will back up any damage for a length of reasonable time you should still use that shop, stuff happens and its how its handle aftwards that can make all the differenceHey, Its Moomba time
Its all about the dash - enjoy the dash, as that is your time between the dates
13 Mobius LSV-sold
08 Mobius LSV-sold
03 Mobius LSV-sold
life is about finding the balance between being a responsible adult and staying young at heart
04-09-2013, 09:51 AM #16
04-09-2013, 11:58 AM #17
I had a bad filter once where the seal was not completely set in the ridge on the filter. The bottom line, you always run the engine and check for leaks after an oil change.1998 Mobius
310 HP PCM
04-09-2013, 01:09 PM #18
Not a good day
I learned to change oil at a young age. I was taught to always check under the car a couple times right after you change it and run it, and for the first day or two. I apply the same thing to my boat. Make sure after the oil is changed to check it within the first couple minutes of running your boat, and within the first half hour after that.
I also was taught to run my finger around the filter mating surface to make sure there wasn't a gasket stuck to it.-Jake
04-09-2013, 08:45 PM #19Junior Member
- Join Date
- Jan 2011
2) Show me the filter - see #1. If 'oh, we threw it away' then again they are lying.
3) Whether they double gasketed it or worse didn't install a filter or the plug, there is no way they can know "no damage done" unless they tore the engine down. Life expectancy would certainly be a question.
They are telling you what you want to hear. Personally I would have insisted on being present when they inspected it, as a new engine is thousands of dollars.
04-09-2013, 10:04 PM #20
Funny, I've been changing oil for 30+ years and never even heard of that phenomenon until on here. But, I have definitely heard of it from reliable sources such as a guy at a car dealership, etc. I've never seen it but I'm not surprised because I know how cheaply these filters are made. Best to check if you do your own and be vigilant if you don't.My Mom said I'm not allowed to get wet!
2000 Outback LS (sold)