Results 1 to 5 of 5
08-12-2013, 10:28 AM #1
Instructions on replacing moomba steering cable
The teleflex SSC15418 is the correct model number cable for my 2005 moomba lsv. As far as the install: Yes, A guy on the forum I talked with sent me this and figured I would share. I have been begging on the forum for someone to put it up as a sticky. Here is a link to the PDF with instructions.
On the LSV's the entire floor comes up with the drivers seat still attached. There is 10 screws in the floor and 3 on each side under the seats that angle into the floor(DON"T FORGET THESE!!) The floor should come up easily, don't force it. You might have to remove the U shaped carpet piece above your V-Drive, but its easy. Make sure you turn your wheel all the way left before disconnecting the old cable from the rudder and tie a rope on the end before you pull the old one through. This makes it easy to tie to the new cable and pull it back through. There is like 3-4feet under the steering wheel that the cable runs you can't see or get to so the rope trick helps a lot! Also on your new cable grease it really good before you install it to the rudder. You can push it in and out several times regreasing with a marine grade grease. It will help the long term life of the new cable. Let me know if you have any questions or run into any issues. Hope this helps!
http://www.moomba.com/msgboard/album.php?albumid=1352005 Moomba Mobius LSV
ACME 1433 prop (newest upgrade)
1900lbs Surf side