Page 2 of 2 FirstFirst 12
Results 11 to 19 of 19
  1. #11
    Join Date
    Aug 2013
    Location
    Richmond, VA
    Posts
    108

    Default

    I will try to get the exact measurement for you this weekend, but I clear the door buy about 1/2" I believe.

    As for the trailer I believe it is the leaf spring design, but I will check that too. When I got my boat there was some discussion on here as to whether there was any difference between the torsion and leaf spring design and I think the general agreement was there wasn't much difference between the overall ride height.

    I will look at the tower too and see if adjusting the retaining cable will allow for any further drop.

    Like I said I was very skeptical when we bought ours but I was very pleased with how easily it went in with just removing the board racks and changing to a drop hitch once back at the house. The only thing about changing to a drop hitch is the Fulton dolly will not go low enough to get the tongue onto the drop hitch so I have to use a jack to change hitches. Currently I am looking into changing the factory dolly thing and either getting one with a smaller wheel or just a pedestal one so I don't have to go get the jack out of the garage.
    Rusty

    2013 Mojo

  2. #12
    Join Date
    Nov 2003
    Location
    Land O Lakes, Florida
    Posts
    5,852

    Default

    I did adjust the retaining cable to lower my tower down, pretty simple job once you know how.

    for the winter storage i wonder if the removal of the tower could be just about as easy as messing around with swapping hitch balls, dealing with a floor jack and then the tower is out of the way for access into the boat while garaged.
    Hey, Its Moomba time

    13 Mobius LSV
    08 Mobius LSV-sold
    03 Mobius LSV-sold
    life is about finding the balance between being a responsible adult and staying young at heart

  3. #13
    Join Date
    Oct 2008
    Location
    Arkansas
    Posts
    633

    Default

    Quote Originally Posted by moombadaze View Post
    Ifor the winter storage i wonder if the removal of the tower could be just about as easy as messing around with swapping hitch balls, dealing with a floor jack and then the tower is out of the way for access into the boat while garaged.
    Nota, it takes about 15 min or less to swap hitch it in.

  4. #14
    Join Date
    Mar 2012
    Location
    South Carolina
    Posts
    769

    Default How to garage my futur Mojo ?

    Here's a possible solution since you don't need to get it in/out each time.

    11" inch drop hitch from harbor freight ($26)
    Floor jack to lower the tongue enough to get it on the hitch ball.

    Is your garage deep enough? Taking swim platform off?

    ImageUploadedByTapatalk1383328502.764002.jpg
    2008 Supra 21V
    2,600 lbs., Gravity III
    Z5 Cargo Rack
    Stereo: Pair of Wetsounds Pro 80's, Rockford Fosgate P500-2, Kicker ZX200.4, Exile ZLD, stock Kicker in-cabins, stock Kenwood HU
    Tow rig: 2008 Slate Tundra, Bilstein 5100's (F&R), 295/65/18 wrapped in Duratracs

  5. #15
    Join Date
    Jun 2008
    Location
    De Pere WI
    Posts
    4,139

    Default

    Quote Originally Posted by moombadaze View Post
    I did adjust the retaining cable to lower my tower down, pretty simple job once you know how.

    for the winter storage i wonder if the removal of the tower could be just about as easy as messing around with swapping hitch balls, dealing with a floor jack and then the tower is out of the way for access into the boat while garaged.
    I'd be concerned taking the tower on and off from a strength standpoint. The less I have to tighten/loosen bolts set on the 'glas the better imo. I see cracks setting in.
    '06 Supra Launch 20SSV-gone but never forgotten

  6. #16
    Join Date
    Nov 2003
    Location
    Land O Lakes, Florida
    Posts
    5,852

    Default

    Quote Originally Posted by sandm View Post
    I'd be concerned taking the tower on and off from a strength standpoint. The less I have to tighten/loosen bolts set on the 'glas the better imo. I see cracks setting in.

    i was thinking about just undoing the 2 pivot point bolts, not the base. sorry for not being so clear as i was just thinking out loud
    Hey, Its Moomba time

    13 Mobius LSV
    08 Mobius LSV-sold
    03 Mobius LSV-sold
    life is about finding the balance between being a responsible adult and staying young at heart

  7. #17
    Join Date
    Dec 2012
    Location
    Trois-Rivieres, Quebec
    Posts
    139

    Default

    I was also thinking about the pivot bolts when I was thinking of removing the tower.

    And Rusty, thanks for the effort of measuring the boat...

    In fact, thanks all for the advices....I really love this forum....and I can pratice my english!!!

    And Cigars, my garage is more then deep enough..
    Sampp

    2014 Mondo

    Could be worst
    From nice Québec..

  8. #18
    Join Date
    Mar 2012
    Location
    South Carolina
    Posts
    769

    Default How to garage my futur Mojo ?

    Hey it took me about 8 minutes to do the whole drop hitch and floor jack. IMO way easier and less time that actually taking the tower off.
    2008 Supra 21V
    2,600 lbs., Gravity III
    Z5 Cargo Rack
    Stereo: Pair of Wetsounds Pro 80's, Rockford Fosgate P500-2, Kicker ZX200.4, Exile ZLD, stock Kicker in-cabins, stock Kenwood HU
    Tow rig: 2008 Slate Tundra, Bilstein 5100's (F&R), 295/65/18 wrapped in Duratracs

  9. #19
    Join Date
    Dec 2012
    Location
    Trois-Rivieres, Quebec
    Posts
    139

    Default

    Anyone who has a Mojo could mesure how high is the boat on the trailer?

    Thanks
    Sampp

    2014 Mondo

    Could be worst
    From nice Québec..

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •