Page 2 of 2 FirstFirst 12
Results 11 to 16 of 16
  1. #11
    Join Date
    Jul 2012
    Location
    Pearland Texas
    Posts
    191

    Default

    I sure wished they would start pre wiring from the factory as well. Im running 4 rev8 and it was a pita
    Chris H.
    2012 Mojo
    Wake Life

    WS420sq,4 Rev8's,JL Amps,2-TypeR 12's,6-Interior Kicker, Green/White LED

  2. #12
    Join Date
    Aug 2013
    Location
    DFW
    Posts
    382

    Default Putting Tower Speakers on a Mojo

    I'm doing the 4 XM9s tomorrow. Finishing my amp board now... Waiting for carpet glue to dry
    Matt
    2012 LSV
    4 XM9 Towers
    Javelin & XM30.2
    Xi 12DVC Sub
    2 6V Golf Cart Batteries
    FAE

  3. #13
    Join Date
    Jun 2012
    Location
    Portland Oregon
    Posts
    825

    Default Putting Tower Speakers on a Mojo

    Awesome get plenty of pics!
    -Jake

  4. #14
    Join Date
    Aug 2013
    Location
    DFW
    Posts
    382

    Default Putting Tower Speakers on a Mojo

    It took me a while to figure it out after I drilled my holes yesterday, but I found a fairly easy way to run the wire in the tubes. I used my fish tape to run a real heavy test fishing line from the bottom to the top. When the tape was past my drilled hole, I would grab the fishing line with a hook from this kit (http://www.lowes.com/ProductDisplay?productId=50158911 I had just happened to buy the kit earlier in the day because I needed an awl). I would then cut the line and tie it off. Next, I would repeat jumping from hole to hole. Once all the fishing line was run, I pulled the wire.

    You can see here where my wires all exited the tube. I used the larger pre drilled hole on the right to connect 3 out of the 4 speakers to the main run.

    Matt
    2012 LSV
    4 XM9 Towers
    Javelin & XM30.2
    Xi 12DVC Sub
    2 6V Golf Cart Batteries
    FAE

  5. #15
    Join Date
    Jul 2010
    Location
    Vicksburg, MI
    Posts
    554

    Default

    What is with the group of wires just above the driver's seat?
    Joe

    2014 LSV
    2010 Outback V - Sold

  6. #16
    Join Date
    Aug 2013
    Location
    DFW
    Posts
    382

    Default Putting Tower Speakers on a Mojo

    I used the larger hole where the grommet is to tie them all together.

    The cable is a 4 conductor, so in that bunch, there are 4 leads.

    1 is the main feed, 2 are for the right speakers, and the other is for the left speaker on the rear crossbar. The far left lead you see goes down the tower, and will tie in at the amp.
    Matt
    2012 LSV
    4 XM9 Towers
    Javelin & XM30.2
    Xi 12DVC Sub
    2 6V Golf Cart Batteries
    FAE

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •