Results 1 to 10 of 10
04-03-2014, 08:53 PM #1
04-03-2014, 09:07 PM #2
someone had a little to drink tonight'06 Supra Launch 20SSV-gone but never forgotten
04-03-2014, 11:40 PM #3Junior Member
- Join Date
- Jun 2013
- San Antonio/Marble Falls
04-04-2014, 10:16 AM #4
I'll have to check back around 11 pm and see if that post makes more sense.My Mom said I'm not allowed to get wet!
2000 Outback LS (sold)
04-04-2014, 10:23 AM #5
04-04-2014, 06:48 PM #6
LOL Not Sure What That Was....Anyway, I'm going to be redoing my in boat speakers and was wondering if it would be a problem to run a 2ohm amplifier at 1.34ohm2008 Outback
04-04-2014, 08:24 PM #7
Think I just answered my own question on how to wire my in boat speakers, I'll run them like this to see a 2.67 ohm load at the amp three speakers on the left and three on the right of a 4ch amp and bridge the other channels to the sub....
04-05-2014, 11:15 AM #8
You are satisfying the amplifier's minimum impedance load requirement but ignoring the fact that you are distributing the power in an unequal manner. Try it first to see if you are pleased with the balance of volume between the speakers.
While there will be a power difference but if you don't hear a difference then it is okay.
04-05-2014, 05:38 PM #9
04-08-2014, 08:21 AM #10
I recently just redid all of my cabin speakers, like you had said, three to the left channel, 3 on the right channel in the 2.67 ohm's... no problem what so ever, It honestly sounds awsome!! my wife was impressed when we got out on the water and I cranked it up... I am running my towers currently off the same 4 channel for now, no problems as of yet.B.J. Reed
2006 Moomba OBV