I saw several mold-specific products in the boating aisle at fleet farm the other day. lots of stuff out there, but I'm with jm in that simple green is typically the first go-to for issues...
wonder if you could put a towel down between them to keep them from touching. would mold then form on the towel vs boat?
I know there are small 12v fans that some keep on the floor when stored if you have access to a battery charger to keep the batteries fresh while sitting.
Results 11 to 14 of 14
Thread: Babes cleaning
06-01-2014, 10:08 AM #11'06 Supra Launch 20SSV-gone but never forgotten
06-01-2014, 02:48 PM #12
I've made a pvc pipe frame for my previous boat that kept the cover off the boat. The pipe bends real well.1998 Mobius
310 HP PCM
06-01-2014, 03:10 PM #13Senior Member
- Join Date
- May 2014
- Clermont, Fl
PVC frame - I did the same thing with the Outback. worked real well.
Not so much with the OBV. That sundeck is a lot bigger - more surface area.Ed Geary (Ed G)
2009 Moomba Outback V (Moomba Martha The Magnificent)
06-01-2014, 04:41 PM #14
I have used the 3M mildew remover and it worked well..now after reading and it saying that to use a brush to work it in I'll try it again. Also I have the give props to joe, babes works well and I love the smell..just wish they would give our dealer a break so I could buy from them..I'll also have to try a pvc frame for the cover..I use the 3/4 inch lbs for gopro mounts and I might try to make a flag pole since I have extra haha2004 Outback Blue/white w/5.7 indmar 350, Direct Drive
Rockford fasgate cabins
Rockford fasgate 500w amp (cabin) and a kenwood HU (kmr700u)
Polk 10in sub (2)
Polk P330 amp (subs)