One other tip if you are not familiar with doing brake jobs and this is your first- use a big C-clamp to compress the piston down on/into the caliper before reloading your new, thicker pads. It will open it up enough that it will go over the rotor much easier than fighting it on.
Results 11 to 15 of 15
06-24-2014, 01:09 PM #11Old enough to know better, young enough to do it anyway.
06-24-2014, 09:55 PM #12
Awesome write up, congrats on the sticky, and thanks for mention!
A couple follow up questions:
When reapplying the grease, how much do you put in? In addition to packing the bearings, do you fill the void around the spindle between the bearings and fill the vault cap? Can you put in too much grease?
Also, how tight should you make the spindle nut when putting everything back together?
Thanks again and great job!2008 Mobius LSV
1100#er's in the lockers
ski locker sac
3 vent heater (which my family loves)
06-24-2014, 10:36 PM #13
How To: Replace your trailer axle seal2008 Supra 21V
2,600 lbs., Gravity III
Z5 Cargo Rack
Stereo: Pair of Wetsounds Pro 80's, Rockford Fosgate P500-2, Kicker ZX200.4, Exile ZLD, stock Kicker in-cabins, stock Kenwood HU
Tow rig: 2008 Slate Tundra, Bilstein 5100's (F&R), 295/65/18 wrapped in Duratracs
07-01-2014, 12:45 PM #14
How To: Replace your trailer axle seal
It down, then back it off about a quarter to one third turn. You don't want it all the way tight because then there is no room for heat expansion. Also just pack everything with as much grease as possible. I always fill the hub before I slide it on the spindle to ensure there is grease all in there and then fill that vault cap up about 3/4 full
Sent from my iPhoneDavid
2008 Mobius LSV, Gravity III , Wake Plate, Z5, Exile SX65c's, Exile XM9s, Exile XI12D, Exile Harpoon, Exile SM600.1 , Exile Xi800.4.
07-01-2014, 01:59 PM #15Member
- Join Date
- Jan 2011
- Western PA
I agree, I tighten the nut with channel locks till it is pretty tight, back it off a ways, then hand tighten to where the cotter pin will go thru.2004 Supra 22 Launch SSV
325 Indmar Assault 320 HP
"One more hour"