just wanted to share this. i made this in about two hours which includes 40 minutes drive time to home depot & back. west marine sells them for $40.00.
1/2" FIP x 1/2 MIP (or slip) adapter PVC
1/2" MIP x Garden hose adapter
1/2" O rings (rounded type)
cut hole slightly smaller than 1/2" in plunger, insert garden hose adapter with O ring, screw PVC adapter to garden hose adapter inside the plunger head.
Results 1 to 5 of 5
Thread: Homemade Flush Kit D-drive
01-25-2010, 12:35 PM #1
Homemade Flush Kit D-drive'08 OBV-gravity III with two 550 lb & one 400 lb, 3 pair of Kicker KM613 cabin speakers, Kicker KM10 sub, one set KM6500.2 HLCD tower speakers, Kicker ZXM700.5 amp, Kicker ZX450.2 & Kenwood KMR-440U head unit
01-25-2010, 12:53 PM #2
Place proper size brick under plunger handle.My Mom said I'm not allowed to get wet!
01-25-2010, 03:23 PM #3
it was either the brick or try to make my wife hold it in place. i chose wisely.'08 OBV-gravity III with two 550 lb & one 400 lb, 3 pair of Kicker KM613 cabin speakers, Kicker KM10 sub, one set KM6500.2 HLCD tower speakers, Kicker ZXM700.5 amp, Kicker ZX450.2 & Kenwood KMR-440U head unit
01-25-2010, 03:59 PM #4
Looks good! Here is another option for v-drives. I'd recommend using radiator hose though. http://moomba.com/msgboard/showpost....0&postcount=32Dan
08 LSV Mods
01-26-2010, 12:47 AM #5
Or put a broom handle in it and cut to length09 21v LAUNCH
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies