Results 1 to 5 of 5
Thread: Homemade Flush Kit D-drive
01-25-2010, 11:35 AM #1
Homemade Flush Kit D-drive
just wanted to share this. i made this in about two hours which includes 40 minutes drive time to home depot & back. west marine sells them for $40.00.
1/2" FIP x 1/2 MIP (or slip) adapter PVC
1/2" MIP x Garden hose adapter
1/2" O rings (rounded type)
cut hole slightly smaller than 1/2" in plunger, insert garden hose adapter with O ring, screw PVC adapter to garden hose adapter inside the plunger head.
5.jpg'08 OBV-gravity III with two 550 lb & one 400 lb, 3 pair of Kicker KM613 cabin speakers, Kicker KM10 sub, one set KM6500.2 HLCD tower speakers, Kicker ZXM700.5 amp, Kicker ZX450.2 & Kenwood KMR-440U head unit
01-25-2010, 11:53 AM #2
Place proper size brick under plunger handle.My Mom said I'm not allowed to get wet!
2000 Outback LS (sold)
P5 Danielo Diamond 58"
01-25-2010, 02:23 PM #3
it was either the brick or try to make my wife hold it in place. i chose wisely.'08 OBV-gravity III with two 550 lb & one 400 lb, 3 pair of Kicker KM613 cabin speakers, Kicker KM10 sub, one set KM6500.2 HLCD tower speakers, Kicker ZXM700.5 amp, Kicker ZX450.2 & Kenwood KMR-440U head unit
01-25-2010, 02:59 PM #4
Looks good! Here is another option for v-drives. I'd recommend using radiator hose though. http://moomba.com/msgboard/showpost....0&postcount=32Dan
08 LSV Mods
01-25-2010, 11:47 PM #5
Or put a broom handle in it and cut to length09 21v LAUNCH
99 Outback LS. Sold
run your engine after you change your oil
68 th Member. WS420,HSE Revolution, OJ 466, Acme1157,1100 sacs,Kicker HLCD's n IX500.4, Supra Coolies